Why do I have to push down the BOOST HD Absorbent Pad after I spray? BOOST HD Stain Eliminator solution contains surfactants that allow stains to be pulled away from the concrete and into the BOOST HD Absorbent Pad. How much BOOST should I use on a stain? For a 12 x 12 (1 SQ FT) stain, use 1 ounce of BOOST HD solution. BOOST HD is designed to work with other CAF products like EXIMO in maintaining an ongoing clean outdoor appearance. Regularly scheduled cleanings ensure location cleanliness standards. How often should BOOST HD be applied? BOOST HD should be applied as needed. For stubborn or heavy stains, reapply BOOST HD and BOOST HD Absorbent Pad to the area for an additional 30 minutes. Rev XMOFQ130806ģ MULTI-SURFACE STAIN ELIMINATOR CLEANER How long should I leave the BOOST HD Absorbent Pad in place? Remove the BOOST HD Absorbent Pad after 30 minutes and let the area dry. This is nature s way at work, eating the hydrocarbon (oil stains) and turning it into harmless carbon dioxide and water. Under certain conditions an enzymatic reaction can be observed with the oil stain turning white. Is EXIMO just cosmetic or does it really clean the concrete? Cleaning begins immediately after application and continues for up to 30-days. EXIMO has a high specific gravity that works to fill the pores of concrete and establish a protective barrier that will start the cleaning process immediately and consume future oil stains. Is it true that EXIMO should be applied to new locations before opening? Yes. Using EXIMO can save up to 75% over pressure washing. Application does not require closing off the entire operation. Waterless cleaning is more efficient and leaves a brighter, cleaner surface. How is EXIMO better than pressure washing my location? Unlike pressure washing, EXIMO is environmentally friendly and does not violate environmental regulations. EXIMO should NOT be applied during extreme winds or gusty conditions. Try applying the minimum amount of product required to treat a smaller area of concrete surface. The application is creating a lot of dust Am I doing something wrong? Using too much EXIMO during application may cause dust. If excess product remains, continue sweeping product until all product is dispersed. How do I know when I am finished applying EXIMO? Application is complete when the product has been evenly spread out and no excess product remains. You can treat one section at a time, while leaving other areas open for business. After the application, the area is ready for use. Do I have to block off the entire facility when applying EXIMO? No - only section off the work area necessary to ensure personnel safety. Please follow all company and product safety procedures during use. Concrete should be dry before applying EXIMO, but it is OK to apply before concrete becomes wet. What preparations are needed before applying EXIMO? Clear away any debris and dispose of any trash. For best results, start with less product and apply additional product as needed. On average, 1/4-cup will cover 55 SF, the average size of 1 fuel lane or 1 parking space. How much EXIMO should be applied per application? EXIMO s coverage area can vary depending on the cement s surface texture, with rougher surfaces requiring more product. An average fuel location should apply the product every 1-3 weeks. Application frequency will vary by site based on traffic and oil accumulation. Target stains should be treated as necessary. 2 WATERLESS CONCRETE CLEANER How often should EXIMO be applied? EXIMO should be applied regularly to continue to remove oil stains and treat new oil.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |